9 replies
by dmiles
Check the new memory and insure it is compatible to the memory that you have installed in system,you will want to use compaq specified memory modules with the system,they donot work well with other memory types.
You can try changing the memory banks,inserting the new memory first and then the old memory module
No,there is little risk in flashing the bios,follow the instructions and all will be well
by jimdana1942
by sfhsgrad00
by jimdana1942
by sfhsgrad00
by jimdana1942
by otl
Ran into same type of problem with a 4716 (EDO only), would only work with 2 of 4 sticks in the first slot. Found out later at work that compaq has an affinity for lower speed memory, with very tight specks on what it will accept (70+/- 2 ns access)73/67 ns would not work on that particular PC! 4 sticks and reboots later the normal IT people found memory that would work with that PC. It was the pickest PC I have seen.
Tried reversing or only booting with the new ram? May be an ram/bus speed problem.
by jimdana1942
by jimdana1942
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending