14 replies
by nrodriguez
I know this sounds dumb but check the bios. make sure that it is turned on. Remember
com1 irq 4 com2 irq3 com3 irq4 com4 irq3
then make sure that in NT you have the ports assigned this way. check the irq status in nt diagnostics.
post a comment if this doesn't help
by mikeheitz
by trekker
by mikeheitz
by timecube
by mikeheitz
by ckaylam
What is such error. have you ever check the event viewer to see any conflict ? Please check it and let me know the result
My email address is kaylam45@hotmail.com
by mikeheitz
by rfraysier
Was Plug and Play turned off in the bios before NT was installed? If not NT will see the ports as being in use by system resources and not available when you try to configure your modem. Try using a different com port configuration (i.e. Com 5 IRQ10) if your modem allows that.
Roni
by mikeheitz
by wayne.maples
maybe I am being stupid. I am running Windows NT workstation and I do not have a SERIAL service. Are you talking about workstation or server?
I have a modem and an ADSL connected (not simultaneously).
-Wayne
by mikeheitz
by jewright
Mike,
I have delt with many Thinkpads and can tell you for a fact that a Thinkpad 600 E has it's serial port disabled by default. To enable it, either boot into Windows 98 and disable the IR port or better yet, download the NT Thinkpad utility package from IBM for your machine.
Good Luck.....Jeremy
by mikeheitz
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending