Question Locked

Apple Mac browsing net neighbourhood over VPN

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi everyone... this one has me tearing out the little hair I still have left...

I have an established MS Small Business Server network with a DSL Internet connection and incoming VPN that works very well - all Windows clients that connect to it can do *everything* over VPN that they can do in the office.

The challenge is with the one user who has a Macbook. I have set up a VPN connection and it works - the user can send & receive e-mail (Exchange server on the same SBS). But the problem comes when trying to browse network neighbourhood (works just fine in the office but doesn't see any computers when connected via VPN).

So evidently the Mac doesn't "get" netBIOS over TCP/IP when using VPN. Does anyone have any experience of getting it to work? I don't like the Apple's user interface at the best of times, and trying to find any place that I can configure stuff or do troubleshooting in it is a "little" frustrating. For instance, how do I go direct to a network resource by typing in "\\servername\sharename"? Doesn't look like you can.

I'd really appreciate some input on this one! Thanks!

4 replies

by bfilmfan

The most likely cause of the issue is that the ports used by NetBIOS are disabled and not allowing traffic over the VPN connection.

Ports 135,137 -139 and 445 all need to be opened for the computer browser service to function correctly.

by chrisbedford

...opened where, though?

Windows computers can browse, which indicates to me that the network & VPN server are fine, so that only leaves the Mac with those ports closed. Any idea how to configure ports on a Mac? :-(

by chrisbedford

Looks like you only get to see stuff on a host you explicitly map to, using a Windows client.

So I guess the question really should have been either
(a) how to open those ports, if indeed it is possible to make NetBIOS go over the VPN, and / or
(b) how to explicitly map drives on a Mac. In Windows, easy: open Explorer, type \\servername\sharename and hit [Enter]. On a Mac: not so much.

Anyone with some wisdom to share here? :-)

This discussion is closed to new replies.