10 replies
by donq
140.001; 140.002; 140.003; 140.004;.......
141.001; 141.002; 141.003; 141.004;.......
142.001; 142.002; 142.002; 142.004;.......
143.001; 143.002;.......
144.001; 144.002;.....
145.001; 145.002;...
146.001; 146.00...
by allamp
by allamp
by kfedor
This is impossible. The issue in that you can
not exactly obtain a subnet mask that fully cover you 135 host. I mean that 135 lay in range from 128 to 255 that correspond with consecutive ip subnet 255.255.255.128,
255.255.255.0.
In first mask you obtain subnet with max 126 hosts, with second mask you obtain subnet with max 253 hosts.
Solution: You mast revise you requirement to obtain subnet with 135 hosts.
by kfedor
by allamp
by dlw6
You must use Variable Length Subnet Masking. It's only a bit more complicated than regular subnetting.
I don't have exact numbers of hosts for each of your segments, so the following walk-through is just an example.
For your large (135-host) networks, use a 24-bit subnet with a mask of 255.255.255.0. Let us say that one is x.x.140.0 for the large network, and x.x.140.3 for another large network.
Now, say you have a medium-sized segment with no more than 60 hosts. For that you can usea 26-bit mask (255.255.255.192). Let us say you have two of those which can be x.x.141.64 and x.x.141.128 for two medium sized networks, and if you need two more medium ones you can add x.x.142.64 and x.x.142.128.
At this point, you have two Class C sized subnets and four 60-host sized subnets, but you can squeeze even more out of it with VLSM.
Now, let's say you need more small networks of 30 hosts each. You use a 27-bit mask for these, and (this is where it gets tricky) you can use the space that was wasted by the subnets I already named above. For example, you can use x.x.141.32, x.x.141.192, x.x.141.32, and x.x.141.192 with a mask of 255.255.255.224.
Your 6-host networks could use a mask of 255.255.255.248 with network addresses in the range of x.x.x.8, 16, 24, 224, 232, and 240.
This example gives you two Class C-sized, four 60-host, four 30-host, and 12 6-host networks, all from only the 4 Class C's you started with.
The hard part is keeping track of the different subnets. You'll want to diagram it out, and if you hook it up and machine A can see machine B but B can't see A, then you'll want to check the subnets on each.
VLSM makes more sense if you chart the possibilities out, and if you e-mail me at don-willadsen@us.army.mil I'll share my chart with you.
Good fortune,
Don
by allamp
by allamp
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending