Question Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
1Gig internet line enters the house and connects to Motorola DOCSIS 3.1 cable modem. The modem connects to port-1 of a 10-port TrendNet 2.5G switch. During a recent renovation, I ran 10 Cat6 home runs to various rooms in the house. I'm connecting port-2 of the switch to an ASUS ZenWifi AX6600 XT8. That XT8 is set up as an AIMesh router. I want to run port-3 of the switch to another XT8 in another part of the house to get adequate network coverage. When I connect the second XT8 it setups but uses the wireless connection versus finding the router through ethernet. I then factory rebooted the second XT8 while also changing the system settings for the router and turned on ethernet backhaul mode. After doing this I set up the second XT8 again and it was found but then went into continual sync with the router and never came back. The diagrams for the system seem to show that the equipment has to be hardwired together straight-shot rather than through a switch. Does anyone know if this is a requirement or what settings I might be missing so I can set it up for my config? In addition, my computer connected to one of the ports on the switch does find my printer on a different port. TIA.
4 replies
by rproffitt Accepted solution
In your classic ISP setup it's:
MODEM-> ROUTER-> SWITCH.
You claim you have a MODEM -> SWITCH with is fine under some rare conditions. In other words I do not expect this to function. Maybe the MODEM is not just a modem but has a router in it? I can't tell because the full model isn't told yet.
As to how to wire XT8s and their system, ask the maker.
by steven1636211901 Accepted solution
Aha. Sounds like standard user error so I will try "classic design" as I believe the Motorola MB8611 is simply a modem and does not include router functionality. At least you didn't have to ask me to turn it off and on again. thanks.
by steven1636211901 Accepted solution
Thanks!
by rproffitt Accepted solution
JK (just kidding.) Glad it was something you could fix. Once in a while it gets harder than it should be.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies