Discussion Locked

Audit not working

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

NT 4.0 SP5
I can't get the AUDIT Feature to work.

Using User Manager for Domain / Policies / Audit, I have turned on "Audit These Events." Because it's not working I have turned on "all" events just to get some kind of response.

I then created a test subdirectory, went to Properties / Security and set the properties on that directory to allow Domain Admins only. Then I went to the Properties / Auditing and set it to "all" options for the Domain Users.

When I finish the Properties Setup I get the message "The current audit policy does not have auditing turned on. Ask an dministrator to use User Manager to turn on auditing."

I have turned it on. I've been going around in this circle for two days. Any ideas?

7 replies

by spydergst1

Be sure to set auditing in user manager for domains. Then add the auditing to the directory.

by spydergst1

Be sure to set auditing in user manager for domains. Then add the auditing to the directory.

by spydergst1

Sorry. OK SP 5 has some issues. I recommend upgrading to SP6a. I just tried to duplicate your error by following the same steps you took. Without sucess. I have SP6a installed. Maybe that will make the difference.

This discussion is closed to new replies.