Discussion Locked

Automated saving your ERD to FAT

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

When setting up your NT partions. Create a 400+ mb partion in FAT instead of NTFS. Copy the i386 cabs to it. Would it be possible to have your ERD save an update to this FAT partion weekly? if your computer file becames corupted,
boot-up with a dosboot disk. Save the ERD and repair from there? If this would be possible how would you write a script to save the ERD info to this drive? I'm fairly new to Nt administrating and I've been reading your articals
(which have been great!) the one artical about saving your ERD was very informing but this may take it to the next step, If its possible.
Thank you
Russell Wagner
russell53@trdesk.com

2 replies

by lewey04

I am assuming you are familiar with writing batch files. Just setup this simple batch file and run it with the AT or WinAT command.

rdisk /S-
copy c:\winnt\repair\*.* e:\repair

Of course, I am assuming that is where your repair folder is ande: is where you want to make a copy of your erd. If you aren't familiar with the AT command you can email me at raymond62@trdesk.com or lewiray@hotmail.com. Good luck. Hope this helps.

by shanghai sam

Thank you, If you don't mind I'll take you up on the offer of e-mailing you. I'm not that familiar with AT commands. thanks again

This discussion is closed to new replies.