Discussion Locked
0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
When backing up a share(win98 m/c fat32) in a NT server 4.0 incremental backup is not working ,every time fullbackup is done,does the archieve attribute work in this condition? is there any way to solve it?
3 replies
by bowieb
In order for the incremental backups to work properly, the backup program must be able to write to the directory to turn off the archive bit.
Make sure that your directories are shared as full-access and not read-only and it should work properly. There is a security risk in allowing full access to the share. You may want to set full-access to be password protected and then just use the password when you connect to the share on the NT system.
by mahi.nsg
Poster rated this answer
by mahi.nsg
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Unanswered
How Can IT Teams Detect Hardware Bottlenecks in Business Networks?
0 helpful
0 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies