Discussion Locked

Backup Tape Drive performance

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Currently we're running a DDS-3/Veritas Backup Exec 7.3 combo on our 70gb server. The combo of the DDs-3 tape (24gb) and Veritas has been problematic since I took over the position of CTO. I'm about ready to dump both products. I'm currently reviewing the possiblity of trying the Onstream SC50 device with our copy of Veritas 7.3. Anyone have experience with the Onstream drive(s)?.

7 replies

by re_hughes

What kind of problems?
Performance? What controller are you using?

richard477@trdesk.com

by smartsurfer

The Onstream drive while an excellent low cost product, is not a very fast drive. I remember talking with Onstream at PC Expo when this product was introduced, and because of this factor alone, I had to skip deploying it.
If the volume of data and the time you have to backup is limited I suggest the new Sony AIT-2 (50Gb/100Gb) drives. I have a an auto-tape loader with dual drives, and the backup time is very short (relative to my older Exabyte 8mm 7/14G based autoloader.
The data is expected to grow significantly over the next few years, and the autoloader (ADIC Scalar-480/software combo(CA's Arcserve-IT)should work well for us.
I hear that Exabyte's Mammoth-2 is faster (~2x), but have no experience with this product. It is probably worth looking in to.
Recent Veritas's product reviews state that it is supposed to be much easier to install and use than CA's Arserve-IT. Veritas recently stated that their product can read CA's Arcserve-IT products, so if youhave older CA ArcSer

This discussion is closed to new replies.