Discussion Locked

BAD ROUTERS?

0 helpful
10 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

we recently configured a router into a lan as a firewall from the dsl modem. the router is a dhcp server and all nodes on the lan are running tcp/ip. everyone has internet and lan access.
soon after this site started loosing it's internet connection (the browser opens and attempts to find the homepage, but fails). re-initializing the router and modem usually restores the system to operating condition; however, the frequency of this problem increases. in time, rebooting devices no longer restores the internet connection. the lan runs flawlessly.
we replaced the router with one from a different manufacturer. the system was configured successfully...however, the same problem surfaced.
this same pattern has occurred at a second site that we installed.
Can somebody help me out here?
Thanx,
BigMarty

10 replies

by zen37

Its a long shot here but have you configured keep alive between your router and the DSL. I had to do that here to prevent my DSL connection from "hanging up". From what you tell us, the problem should not be the router but either configuration or a DSL issue.

Check with your DSL ISP to see if there is a timeout on the connection. If so, either have it turned off or generate keep alive from the router.

Good Luck.

by rjeffery

It sounds suspiciously like a DOS attack on your firewall/router. Are you able to monitor the traffic to your firewall/router from the internet during the outage periods?
Regards,

by bigmarty

Zen33 answered this for me...it was a KEEP ALIVE solution between the router and the ISP.
Thanx,
BigMarty

by otl

Did not mention anything about port stats from the router. A dirty line/bad connection could cause the same pattern of problems as you have stated. Tried swapping cables when it goes down to see if it clears it for a longer peroid?

Not real slick on DSL, but if memory serves me (Documentation in the office) basically DSL is a T1 (thottled back at the node), thus the customer service unit (DSL modem) is changing number of bandwidth channels dynamically. Still using the same modem and line?Also saw numerous problems with the NIU (Network Interface Unit), this is a software loopable device installed for your ISP to test the round trip circuit path.

Can not remember the name, but there is one line concentrator unit on the market (1 to 4 compression) that is almost never installed correctly and alway gives me a headache.

All indications you have provided point to a problem between you and your ISP, the router is correcting the problem for a short time then the errors are toomuch for the router to correct and the connection (port) drops.

Hope this HELPS.

by bigmarty

Zen33 answered this for me...it was a KEEP ALIVE solution between the router and the ISP.
Thanx,
BigMarty

by xiaxiong

I vote for DOS attacks or virus activity. I don't know what hardware you are using, but I have seen the Cisco 67x do exactly as you discribed, with the cause being Code Red / Nimda attempts. The fix is to disable the router's internal web interface site or at least move it to a different port. In the Cisco example, go into the CBOS in enable mode and type:

set web disable
write

by bigmarty

Zen33 answered this for me...it was a KEEP ALIVE solution between the router and the ISP.
Thanx,
BigMarty

This discussion is closed to new replies.