Discussion Locked

Bandwidth

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a 56k PVC from a remote site to my site. Compression is set on routers so as to handle GIS graphics, e-mail, file, mainframe printing, and saving files to servers at my site. Remote site is a 1 person site. Believe the circuit is shared with other agencies (users) I need to increase the bandwidth for better response time. Any suggestion? Concord stats indicate packets are being lost. BW is not sufficient for a 1 person office!

1 reply

by rzan

Dont forget that not all of the bandwidth is allocated for the data alone. Some of it is used for the clocking signal (CSU/DSU), some for error correction and data compression, leaving you with maybe 10% of total bandwidth for the data. Is this a switched 56K circuit? You should also find out about the circuit itself, if this is on a frame-relay, then you and thousands of other users share this bandwidh. If this is a point to point dedicated circuit and you share it, then of course 56K is not enough. Consider upgrading to 128K ISDN, DSL, or if you have the $$$$, go to a full T-1, 1.544 Mbps.

This discussion is closed to new replies.