Discussion Locked

Belkin N Wireless Failing with Virgin Media Cable Service

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi

I have Virgn Media cable 20mb broadband with an Apple Powerbook 10.4 MAC OS. I upgraded to a wireless router from Belkin, the N MIMO F5D8233UK4 at the weekend.

Direct ethernet connection to the router works but the Wireless internet connection doesnt work.

I followed the instructions and created my wireless network - all fine. The wireless network is visable from everywhere in the house with full signal ... great.

I can browse wirelessly for about 1 minute or less and then it fails to find any of the web pages.

I can sometimess still access the router wirelessly, but more often than not I can't connect to the web or router.

However, I stay connected to the Wireless network.

I've rebooted, changed the SSID, changed the channel all to no avail.

If I link to the router via ethernet, all is fine.

Both the Virgin Cable Modem and the Belkin, have all the lights functioning as described in the manual.

Any ideas?

4 replies

by robo_dev

With WLAN there are two 'states': Associated and Authenticated.

Associated means that the radio can see the network.

Authenticated means that TCP/IP communication can happen.

The authentication of the WLAN is performed through a combination of login (802.1x, WPA, WPA2) as well as the use of encryption (WEP).

You can also turn off authentication altogether, leaving the wlan wide open.

Your issue sounds like the authentication is timing out. Are you using WEP, WPA2, or none?

First of all, you have only the Belkin router, correct? (multiple DHCP servers would not be good).

Is the router running network address translation (NAT)...in other words, is your computer's Ip address a 192.x.x.x or a 10.x.x.x address?

Is the Wireless Radio in your MAC a 802.11b, 802.11n or other? Sometimes if you're using a router which supports multiple standards, it can get confused, so you may need to 'lock it down' to the same type as what's in your computer.

by jmcallaghan

Thanks for the reply.

Q&A below :

Question - Your issue sounds like the authentication is timing out. Are you using WEP, WPA2, or none?

Answer - As standard I'm using WPA2, but I've turned that off as a test and I get the same issue.

Question - First of all, you have only the Belkin router, correct? (multiple DHCP servers would not be good).

Answer - Yep I just got the Belkin Cable Router attached to the Virgin Media Cable Modem.

Question - Is the router running network address translation (NAT)...in other words, is your computer's Ip address a 192.x.x.x or a 10.x.x.x address?

Answer - The setup out of the box is issuing addressed 192.168.2.1 as the router IP, with a DHCP range .2 thru .100 for devices.

Question - Is the Wireless Radio in your MAC a 802.11b, 802.11n or other? Sometimes if you're using a router which supports multiple standards, it can get confused, so you may need to 'lock it down' to the same type as what's in your computer.

Answer - Not sure, I think it handles all up n but I havent seen an option to select which protocols to use. - I'll check.

by jmcallaghan

Hi, thanks for hint

Checked through Apple posts but to no avail.
The wireless connectivity seems fine. Staying connected to the internet for longer than 60 seconds via wireless is the problem.

This discussion is closed to new replies.