Discussion Locked

Best DSL connection on LAN

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm designing a LAN using windows ME, and would like to share 1 DSL connection. I'm not sure if I should use 1 NIC in the main pc to connect to the network and connect the DSL on the uplink port of the hub, or leave the DSL connected to the existingNIC and install a second NIC in the main pc to connect to the network. Can you please give me some advice or where I can find more information on this subject?

5 replies

by shmaltz

The uplink port is not going to help you in this case. The uplink port is made to connect 2 hubs together not for intenet connection.
If you have public IP addresses for each machine that will use this network then you can configure each computer with a public IP address DNS info and Default Gateway to connect (all provided by your DSL provider). And then plug the DSL router (Always-On) into the hub (if what you have is a DSL modem not a router (Always-On) then I'm not sure its going to work, since the DSL modem uses PPPoET to dial up, which also means in most cases that you have a DHCP assigned address,).
If you only have one IP address, then you must use eitehr; a pc that has 2 NICs and acts as a gateway/NAT or proxy server (winME comes with a program called Internet Connection Sharing (ICS) to do just that).
or; you can get a WAN hub that is desiged to act as a router/gateway/NAT. The way it works is it has a WAN port and about 4 local ports (which you can also plug in to a hub), you plug in the DSL connection to the WAN port and the computers/hub to the local ports, then you configure the router to be a DHCP server and, it works. Most of the WAN hubs support PPPoET so you dont have to worry if its a Dial Up DSL or an always on DSL. The price is also cheap about $100-$150.

by wlbowers

Get your self a gateway firewall (DLink DI-701) Connect your DSL modem to the 701, then the 701 to your hub. This device auto assigns tcpip address to the client machines and then nat connects them through to the DSL. The Dlink will nat 128 computers to one tcpip address. If you need to do more than 128 machines Linksys has a unit that will do 250+ (BEFSR11). You will have a simple config that doesn't require a computer to be up and running just so a second machine can get to the internet.
Check this link http://www.dlink.com/../../products/broadband/di701/

Hope this helps
Lee

This discussion is closed to new replies.