Discussion Locked

bios

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Have been attempting to load XP PRO to a clean HD. Needed to stop all mem caching, etc in bios, now it wants password to access the cmos again. Tried all I remember. Even pulled the batt for an hour....still wants that password. How can I clear it, or circumvent that wall?

9 replies

by rickrbyrne

Hi,

Did you remove the power cord from your PSU when you removed the battery, most systems supply a small amount of power to the board that will keep the CMOS intact if not removed from power all together. Now if this don't work you can download Kill CMOS, you have to put this program on a floppy disk, and boot from it. Any Anti-virus program will tell you that this is a virus, but this is not true. It picks up on this as a virus because anything that tries to access your CMOS without your knowledge and wipe it is considered bad, but in this case no its not. here's a link to MacFee so that you know I'm not lying. http://vil.nai.com/vil/content/v_98794.htm
and here is a link where you can download the program Kill CMOS http://www.majorgeeks.com/download2969.html

Rick

by kbuilder22

Thanks to all.....my pee-brain forgot about that power cord.....it worked the second time very well.

by kbuilder22

Thanks to all.....my pee-brain forgot about that power cord.....it worked the second time very well.

by b_pope

To remove the password your going to need to find the manual for the MB, each mfg sets the password reset in a similar manor but they do vary, also check the mfg's site for an updated manual & bios.

Some simply reguire you to move the jumper from pins 1-2 to 2-3 with the power off while others require you to completely remove the jumper with the power off & as noted by post #2 unplug the power cord from the power supply or the wall outlet.

I've had several occassions where the manual shipped with a MB wasn't 100% accurate & has been updated after the fact. A newer bios version can fix many issues including password problems, just check the release notes for each newer bios version to see if that's what might be needed.

by kbuilder22

Thanks to all.....my pee-brain forgot about that power cord.....it worked the second time very well.

by 3xp3rt

See your motherboard manual. You must have some jumpers what need to shortcut for clear the CMOS passwords, and settings.

by kbuilder22

Thanks to all.....my pee-brain forgot about that power cord.....it worked the second time very well.

This discussion is closed to new replies.