Discussion Locked

Blue screen of death

0 helpful
21 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have one PC running NT that ocassionally has a BSOD. A reboot will fix the problem, but I am concerned that this happens at all. It seems to occur randomly, when I am using a program or sometimes when I am not even using the PC and the screensaveris on.

21 replies

by ustutz

Can't get much help with what you have given so far. Best bet is to note down the error message and hex code the next time this happens. With that information you can search the Technet for answers. Do check your Eventlog for any activity immediately prior to the BSOD. But that is a shot in the dark. Other "mystery causes" are hardware incompatabilites, or "copper migration" on the RAM chips (see that all your RAM has the same type of metal for its pins - i.e., some 'silver' and some 'gold' mixed can be a problem).

by dbowlin

BSOD frequently indicates some kind of hardware problem. Try reseating all the cards inside, check the cables, etc. and try reinstalling the drivers. Also try disabling any screen savers.

by vk6xre

BSODs are caused by the failure of a core component. The reason these fail are often traced to bad hardware or a bad driver.

Note the STOP: information (the first 4 lines) and consult Technet.

Try installing the latest Service Pack (6a or later) look into the latest 3rd party HW drivers and then look at swapping out RAM.

Remember NT never sleeps it is always swapping Memory to HD etc. Most problems I have encountered have been bad RAM.

by stephen_ski

yes it does usually indecate a hardware error BUT screen saver ??? this uually indicates a Software DLL corruption....corruption doesn`t always mean the file wont work...it can just causes what seems intermitant errors ...first uninstall your last SP and re-apply you don`t need 6a or somthing 5 is more than enough ..this should cure your probs if not re-install your video driver as this also work at the core level it may cause problems

by leo.valmores

I am more inclined to suspect that it is a memory problem.

Have you tried to re-seat the memory modules? Blow the mem sockets with air duster so you get rid of the minute dusts that could affect contact with memory and socket. If after doing this, the problem recurs, then try replacing your memory with new ones.

Good luck

by clpadmin

The BSOD will actually tell you what the error is. If you could give me the first few lines on the BSOD I might be able to help you.

by garoe48

A lot of good advice but check the simple stuff first. On the next BSOD look at the end of the third line. There should be the name of a program. On my system I have trouble with aic78u2.sys. That's the Adaptec SCSI driver. I don't know how its getting corrupted but if it happens more than a couple of times I reinstall the driver. If its a core program like ntkernel you might be looking at a reinstall. But it sounds like a bad driver. When you use a particular device or program the system goes south. Try each device or program and see which one causes the BSOD. Then reinstall. If it's a different program on line 3 each time it might be time to reinstall.

Best, Glenn

by khwa

I agree with the memory issue. May even try taking your memory out, re-seating the DIMMS/SIMMS..check all connections, update to latest service pack.

This discussion is closed to new replies.