Discussion Locked

Blue screen of death after log in

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Much to my irritation, merely rating answers closed my question!
I'm sorry, but I'll repost this again.

New info: NT 4.0 Service pack 5.

My network connected HP Kajak (333 MHz, dual
processor) frequently crashes upon restarting each
morning. After the restart, I log in and just as I connect
to the network I get the BSD with these error
messages:

STOP 0x0000001E (0xC0000005, 0x80003E2B,
0x00000001, 0x00000030)
KMODE_EXCEPTION_NOT_HANDLED Address
8003E26 has base at 80001000 hal.dll

Dll base directory Date Stamp Name
ntoskrnl.exe hal.dll

And the rest of the memory dump I've snipped.

This has happened intermitently during the two years
I've had the machine. It now
seems to happen several times a week.

4 replies

by Former member

An incorrectly configured device driver usually causes this type of error.

Look at the BSD. Which driver was the next to load (the one on the top of the stack) This was the moduel attempting to load when it crashed.

Another possibility is badmemory...

by smithjj

Yes, I mentioned the hal.dll driver in the error. No one has said how to fix this.

by smithjj

Good link, but it didn't say how to fix the problem. It said:
First, make sure any new hardware installed is listed on the Microsoft Windows NT Hardware Compatibility List (HCL). A buggy
device driver or system service might be responsible for this error. Hardware issues, such as BIOS incompatibilities, memory
conflicts, and IRQ conflicts can also generate this error.

Disable or remove the driver or device whose address is identified in parameter 2 (the driver might also be listed by name within the
Stop message). If the error occurs during the startup sequence and the system partition is formatted with NTFS, you will need to
install a second, parallel installation of Windows NT in order to rename or replace the faulty driverfile. You can then disable or
remove any drivers or services that were recently added.

I don't have NTFS and not a clue on how to "uninstall hll.dll"

This discussion is closed to new replies.