Discussion Locked

boot-start driver failed to load NT 4.0

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am configuring an NT workstation for a user and getting an error message when it starts. The event viewer detail says "The following boot-start or system-start driver failed to load: ppa3nt"
Does anyone know what causes this.
Thanks

5 replies

by mplatts

Are you using a parallel port Zip drive? Usually this is caused when the drive is not attached to the parallel port on boot. Try updating your Zip drive drivers.

by berserker

You can disable the boot-start or system-start driver at the Control Panel/Services/IomaegaAccess and click on the Startup option to disable it.

This discussion is closed to new replies.