Discussion Locked
0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Can anyone tell me what is needed to create a bootable network disk that works on IP.
2 replies
by jay
Go to the NIC's web site. Most brand name NIC support sites have instrucions on how to make a network boot disk for their products.
by craig_vm
If you can get a copy of Windows NT server look in the directory named-->"clients-->lanman-->disks-->disk1. On an old machine (one with a hardrive you dont mind erasing) make the machine bootable to just a dos prompt. Then run the setup on disk1-4. During the install you will be prompted for the drivers for your nic, install them. You will also be asked what protocol you wish to use. Once this is done you can reboot your machine and logon to your network. With a bit of practice you can copyonly the files you need to make a bootable diskette to logon to the network.
Good luck!
This discussion is closed to new replies.
Trending IT Employment posts
Sort by Trending
0 helpful
9 replies
0 helpful
0 replies
0 helpful
1 reply
0 helpful
6 replies
0 helpful
11 replies