7 replies
by papachuck
by dwymer
by raymond wong
Hi,
VPN is already secure, but if you are still weary, you can use use filtcfg to deny all traffic on the vptunnel interface & open the individual ports.
You can also setup a generic proxy with accompanying access rules for telnet so the user will have to pass through the proxy & access rules after establishing a vpn connection.
Cheers.
by dwymer
Usually telnet to the BM server is disabled, because of the huge amount of utilities ready to burn a server using telnet.
You must define two filters in the firewall.
On for input and the other for ouptut across port 23 (telnet)
Also you should run a SET command at the console in order to telnet a BM server.
"SET NAT DYNAMIC MODE TO PASS THRU = ON"
Good luck
by dwymer
by dwymer
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending