Discussion Locked

Cable modem on W2K network w/AD & DHCP

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm trying to install a cable modem and 4-port router on my Win2K network at home. The server is running W2K Server w/AD and DHCP with internal addresses in a range of 192.168.1.16 - .1.48. I can ping the router from the internal network, but I can't ping the Internet side unless I connect to the Internet (using another means). In other words, I can't seem to "cross" the router to allow my network to share and use the cable modem. Any ideas?

4 replies

by highorbit

The router doesn't have routing enabled or it's not forwarding IP packets to the internet.

by marc

Make sure your DHCP gives out the IP address of the router as Gateway, also configure the DHCP to give out your ISP's DNS servers.

This discussion is closed to new replies.