2 replies
by shanghai sam
VLANs can communicate between each other if they go through a router or a Layer-3 capable switch. The standard method is to connect a router interface to a switch in one VLAN and connect another interface on the same router to the other VLAN. Eachrouter interface has to have an address in the appropriate VLAN, and the router interface address is configured as the default gateway on the switch. That way, whenever the switch doesn't know what to do with traffic destined for another VLAN, it sends it to the router. The router then puts the traffic on the interface connected to the other VLAN.
Without knowing what kind of equipment you have, it's hard to be more specific. My experience has all been with cisco. If you have access to their CCO website, you can find information on how to deal with Appletalk on their equipment. Here's a link to a document entitled "Configuring Routing between VLANs with ISL encapsulation."
http://www.cisco.com/univercd/cc/td/doc/product/software/ios113ed/113ed_cr/switch_c/xcisl.htm
Hope this helps! Best wishes,
- ck
by mjiverson
There is only one Layer 3 switch that I know of which will route Apple Talk and that is the Anritsu line of switches. If you don't have one of these, your out of luck unless you use a router for your AppleTalk Zones. The other thing you could do is Flatten your appletalk zones. I am not sure how many zones you currently have, but with over a thousand MACs, your talking a whole lot of traffic. It will also depend how what size of the files you are working with. When you flatten an apple talk zone, you will only have one zone to worry about, and all the MAC's whether they are on one VLAN or the other should be able to talk to each other. Layer 3 will PASS AppleTalk zone info, but will not ROUTE it. So, if you only have one zone spreadacross your VLAN's, your layer 3 switch will PASS that info betwn them, as long as it is the same zone.
I hope this helps.
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending