Question Locked

Can I get a key replacement for keypad

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

My Acer Aspire 5002WLMI AMD Turion 64ML has lost the " F " key on the keyboard.
Can I buy a new single key or do I need to replace the whole keypad on the laptop.

Let me know thanks,
Penny

mercer_penny@yahoo.com

5 replies

by older mycroft

My Aspire 1363 parted company with the ' \ ' key about 6 months ago, I've still got the errant KEY but kind of enjoy the feel of the little rubber nipple. Luckily my missing key isn't as heavily used as yours.

Either you shell out the cost for a new keyboard, or perhaps you could develop a deep interest in creative typing, avoiding the 'need' for the key completely. :D

by captbilly1eye

Bad news first...
Currently, there appears to be no suppliers for single keys. That means the keyboard would need to be replaced to get the missing key back.

the Good news...
A replacement keyboard is relatively inexpensive and not difficult to replace.
Google for replacement keyboards and you'll find several suppliers. Here is one that has the keyboard for your model listed at $23. Keep in mind that this is just an example and not an endorsement since I have never done business with this particular supplier.
http://tinyurl.com/5lrtj5

If you do end up getting a new keyboard, here are the instructions for replacing it:

1. Remove the three screws from top of laptop. These screws hold the power cover (cover which has the power button).
2. Remove the power cover.
3. Remove the two screws that hold the keyboard.
4. You can now disconnect the keyboard and carefully lift it out of the laptop.
5. Reverse the procedure to install the new one.

I hope this helps.

by older mycroft

The keyboard is attached to the motherboard by a rather thin (but wide) ribbon cable.

[b][u]IMPORTANT:[/b][/u]
Where the ribbon cable attaches to the motherboard there is what looks like a terminal connector (something that you would think can be 'unplugged').

It is [u]NOT[/u] a plug - it is a 'slider' that anchors the end of the ribbon cable, so it only SLIDES up a few millimetres to release the ribbon cable. When you insert the new keyboard's ribbon cable, you just gently push the slider back down to anchor it.

I'm saying this from experience. The first time I encountered one of these connectors I all but destroyed it trying to 'unplug' it, not realising that it wasn't designed to be unplugged. ;)

by captbilly1eye

..for watchin' my back.
Just goes to show that nothing is as 'easy' as it first appears. :)

It's been a while since I did one.
Thanks again!

This discussion is closed to new replies.