Discussion Locked

Can I make my A drive in NT a B drive?

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a DOS app that needs to read from a B drive on an NT 4.0 machine that has the standard single 3.5" floppy. Can I fake out NT somehow and it a B drive?

9 replies

by tomcat-2000

This may be unorthodox, but ... can you copy the floppy to a local (or network) drive? If you can, you can create a share, and NET USE B: \\server(or workstation)name\sharename, and it will access it and quite probably work. Good Luck !!

by el machete

There are two ways to do it:
The easy and cheap solution>>>

1) Go to Explorer and make your drive A shareable. Use the Mapping tool to map your shareable A drive as B. Now you can read from Drive B being the same as A.

The more complicated solution>>>

2) Turn off your computer.
Open your computer and change the cables to your floppy disk drive and connect it to the output in the middle of the cable.
Now, restart your computer and go into the BIOS and setup your A drive to none and setup your B drive as 1.44 Mb.
This is a permanent solution. If you need to have your drive as A again you would have to repeat the procedure.

by kevin brown

put a floppy in the drive and execute the following command: subst b: a:
That will do it for you.

by mckaytech

Some or all of the other answers may work, but I thought I would throw one more possible solution into the discussion.

On many motherboards, the CMOS BIOS setup has an option to swap the floppy drives at boot time. The downside is that you have to change that option back if you ever need to boot from the floppy. But at least it's easier than opening the case and swapping the cable.

paul

This discussion is closed to new replies.