Discussion Locked

Can i set up DHCP on nt4 & 2003

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

At the moment i have a 2003 server acting as a PDC on a network with an old NT4 server as a member server (which was the old PDC until i DCpromed the 2003 one). The NT4 server is running DHCP for the network still.
I have recently installed another 2003 server which is a DC & i wish to transfer DHCP over to it. Can i set up DHCP on the new 2003 DC without stopping it on the old NT4 box & can i run them together if need be.

6 replies

by dryflies

You should not run them together. However, as long as they do not overlap IP space you are able to run them together.

If it were me, I would set up the win2k3 DHCP service all the way except for starting it and then pull the NT server off line and launch DHCP on the win2k3 simultaneously and after hours. Since win2k3 does not do the PDC/BDC heirarchy I think DHCP might replicate on both win2k3 servers.

by awfernald

The way to do this is as follows:

1. Set up an inactive DHCP Scope in your 2003 server, utilizing the same IP Address range as your NT4 server.
2. Modify your NT4 server scope to have a lease life of 2 hours. Note what the previous lease life was.
3. Wait for one-half the number of hours/days that the previous lease life was, then.... over the weekend, deactivate the NT4 scope, and activate the 2003 scope (make sure the 2003 scope has your standard DHCP lease life.
4. All IP addresses should be redirected to the 2003 server within 2 hours.
5. If any computers have problems, then the user should be requested to reboot their computer.

Note: You may get a few "duplicate IP address" messages on this, however, as long as you didn't have any reserved IP addresses or static IP addresses, this should not be a major issue.

by promartinus

NO, don;t do it conflicts occours, that's practically tested.

1. You can have both DHCP servers running, that makes conflict, unless you exclude the old nt DHCP
scope in the new DHCP.

a. stop dhcp service on a win2003
b. go to administrative tools DHCP
c. select a authorized computer (your server) as DHCP server,
d. configure adressed parameters, for you network
e. exclude old dhcp adresses scope
f. start dhcp on a new server..

You can also try Microsoft website for migration tools and hepls, it's preety good outlined there.

There is a bigger meaning of DHCP then people use to think, DHCP can send many other informations (not only IP, netmasks, DNS etc..) preety common is the remote OS bootup file location adress, other services IP's etc so be carefull of what your NT dhcp currently is used for.

This discussion is closed to new replies.