Discussion Locked

Can we using clone software to upgrade t

0 helpful
13 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

We have Server with the Operating System Novell 4.12 and 1 GB SCSI the storage size. Until now our storage size almost full, and we have plan to upgrade the storage.

We have already try to run clone software from symantec for IDE storage and we have plan to run clone software with the above situation.

Any suggestion
Thanks

13 replies

by p. dickason, cne, mcse, cca

Hi,
Sounds like you're creating more work than is needed. In netware you can just add another drive then add its space to the volume that needs it. If you do have a need to replace the drive with another, there is a product called ServerMagic 3.0from PowerQuest that would let you manipulate NetWare partitions.
Hope this helps
Pete

by ariefbh

Hi Pete,

Thank you for your comment, I will consider it.

Sincerely,

Arief Bhinneka

by golfkinguk

When you say you're using the Symantec product, I'll assume you're using Ghost. You can do Netware volumes/disks, etc providing you have Norton ghost for Netware. I've used it on many upgrades and it works wonders! There's a trial version available at: http://www.ghost.com/sabu/ghost/ghost_nw/trialware.html
I don't know what it's limitations are though. Good Luck!!

by hasse mcse/brainbench

Hi!

Unless you change any disk controllers or other hardware in server you're going to be able to use cloning software.

DriveImage pro and Ghost are great programs for doing this kind of thing.

DriveImage pro can make an raw image of the whole disk.

/Hasse

by decc

Obviously, adding an additional drive is the easiest way to increase storage space. If you're considering replacing the 1GB drive however consider using Seagate's Intelligent Disaster Recovery. The only drawback is that it works in conjunction with Back-up Exec which you may not be using as your back-up product. I used it to replace a 1GB SCSI drive with a 4GB. This product allows you to restore the basic system files (DOS, Netware & NDS)from diskette then starts Back-Up Exec so you can recatalog your last full backup tape and run a full restore. One comment though, I had to manually add my SCSI driver to the boot diskette as the disaster recovery preparation process did not copy it. Otherwise it worked great.

Good Luck,
Brian

by jlevengl

Two things you can do:
1) install another volume and add it to the first.
2) install a read/write cdrom and mount it as a migrated volume. (I think thats what the thing was called) 'old' files would get moved there and get called back when needed.
Do you have compression turned on the volume? Purge the volume of deleted files to also save space. Jeff

This discussion is closed to new replies.