Windows Forum

Ask something
Discussion Locked

Cannot Access Service Controller (14190

0 helpful
5 replies

by gregberry

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

After installing RAS on a new NT Server (SP5) everything I try to open comes up with the following error:
"Cannot Access Service Controller (1419)" I was also getting another error "The RPC is too busy to complete this request"

Thanks for your help

5 replies

by jdubrow

If you have auditing enabled, ensure that your security log is not full. Also I would suggest changing your settings to overwrite as needed. Hopefully this will help...

by gregberry

Auditing is not enabled. I am not able to open anything to change anything. Thanks for the suggestion.

by ewing bettles

Have you reinstalled Service Pack 5 after you installed RAS? RAS installation overwrites several essential networking files with ones from the original installation media, usually at SP1 level.

Good luck, -Ewing

This discussion is closed to new replies.