Discussion Locked

Cannot add Digital Network Port

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I must configure 10 Digital printers on new Print Server NT4.0, but everytime I want to add new port, I receive message "Specified port cannot be added. Parameter is incorrect.". Searching through Microsofts Knowledge Base I found answer that Spooler servise has to be run as System, and be Interactive. But this is case at this server.
It runs as System & Interactive with desktop.
It is SP5 nt4.0 server with up-to-date hotfixes. Spool folder is on separate logical drive. I?ll try to re-set it as default again. But I need to install those printers as soon as possible...
Can someone help?

5 replies

by cedric king

Check out the KB site posted. By right, it should be fixed by Service Pack 3 and if you got SP5 installed, it shouldn't be a problem. You can direct the question directly to Microsoft.

This discussion is closed to new replies.