9 replies
by mrsneakyz28 Accepted solution
by curacao_dejavu Accepted solution
On the firewall do a port forwarding on port 3389 to the server (internal ip address).
when you think you have it right on the firewall you can use www.grc.com , go to the shields up page, and scan port 3389
you will be able then to connect from remote
Leopold
by mrsneakyz28 Accepted solution
by curacao_dejavu Accepted solution
based on grc's website ?
if it is indeed open you should be able to telnet into it from the internet (you already confirmed that you can do that from the lan side).
"telnet x.x.x.x 3389"
if that is not working then the firewall is redirecting to a wrong device.
just use the ip in the computername.
by mrsneakyz28 Accepted solution
by nimmo Accepted solution
by curacao_dejavu Accepted solution
I see the problem.
verify that from the lan you can connect to the server with rdp.
access to the router and do a port forwarding on port 3389 to the server.
from the internet you need to connect to the public ip address of your router (not the 192.x.x.x one, you need the ip address at the wan side of the router).
use rdp with the public ip address in the computer tab and you are done.
by bapster Accepted solution
by churdoo Accepted solution
Relative to your original question, Curacao was right by recognizing you should be using your public IP address to RDP from outside.
Just to expand on Bapster's post, SBS has Remote Web Workplace (RWW) features built in. Instead of exposing RDP 3389, for SBS2003 forward ports 443 and 4125 to use RWW, assuming you've enabled RWW in the SBS CEICW (Configure Email and Internet Connections Wizard). Then from home you browse to the PUBLIC IP of your site (https://xxx.xxx.xxx.xxx/remote), accept the security certificate warning, and log into the RWW. You'll be able to remote into the server, or into any of your workstations that have Remote enabled, use Outlook Web Access, etc.
If your internet connection at your work site is a Dynamic IP then you'll have to subscribe to a Dynamic DNS service or better yet, convert to a static IP internet plan. It's customary to create an A record in your public DNS zone with your site static IP, something like remote.mycompany.com so that you and your remote users don't have to remember the pub IP.
Somewhat complete list of common SBS 2003 ports used externally:
25 = SMTP, if you're hosting your own email via SMTP
80 = HTTP if you're hosting your own public www site
110 = POP if you're allowing users to POP email from offsite (consider Outlook Anywhere instead)
143 = IMAP if you're allowing users to IMAP email from offsite
443 = HTTPS entry point for OWA, RWW
444 = HTTPS if you're using Sharepoint externally
993 = IMAP SSL
1723 = PPTP, if you're using VPN managed by your SBS
4125 = RWW
--C
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending