Discussion Locked

Canon BJC-4200 color printer problem aft

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This printer worked perfectly with 95. I've upgraded to 98 and have the below errors. Yes, the cartidges have new and full.
It's a Canon BCJ-4200 S

When I go to print in color I get the following error:
Internal Error: Color adjustment methods will not be available.

After I close this bocx I then get:
Attention Low Memeory!
You do not have enough free memory to use BJ series printer driver. Please close unused windows and applications and try again.

This is crap because I have 64 megs ram, 86% of my resources are free and I only have 1 app open, either wordpad or another app.

I've tried 2 drivers: Canonbj.drv ver 4.00
data format EMF.

Also CAN800B.drv ver 4.00 data format EMF.
I've also tried RAW but it still did not work.

8 replies

by elecdata

Howdy, I'm not sure that win98 loaded its self correctly, have you run scandisk on your system? In the past when I would experience that type of problem with a customers unit, I would try to reload windows or just start everything over again.

Bill

by Member 32254067

What i would do in this case is a couple or things. First off i would unistall the printer and any files associated with it. Once everything is unistalled go to the web and get the latest drivers available on the canon site. This is the name of the file on the canon site.

File:
BJSV396.EXE

Size:
3.2 MB

Posted:
July 15, 1999
Once you have downloaded this driver install it and you shall be up and runnig. GOOd LUCK

by otl

I agree with answer 2, but also had to go to the dos mode to adjust the cannon printer to what I wanted (color, font, page size, type of printer) it downloaded a generic bj printer.
Hope it helps.

by jyimcse

What is your parallel port setting? Try changing it to ECP if it isn't already. Go to the bios and change it there. Once you reboot, Windows will detect new hardware and install the ECP(LPT1). False error messages usually stems from errors in Bi-Directional communication with the printer. The software maybe useful, but sometimes a pain in the a$$. Also make sure your bi-directional printer cable is good.

This discussion is closed to new replies.