Question Locked

CanoScan driver for Windows 7?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi.
I have a CanoScan FB630U scanner that used to work on my old computer with Windows XP but it doesn't work on my new computer because Canon doesn't have a driver for it for Windows 7.

Is there a work-around for this?

I hate to scrap a perfectly good scanner!

7 replies

by santeewelding

Change the photo, like, right now.

What are you trying to accomplish? Unreality?

by purpleskys

i like my little recycle avatar... :| ...fine....i'll see what else i can find

by oh smeg

Cannon doesn't make many 7 Drivers and even the ones that they do have 2 versions the 32 & 64 Bit Versions and the 32 Bit Versions [b]Do Not[/b] work on the 64 Bit OS's.

If you are however using a 32 Bit version of Windows 7 most times a Vista Driver will work. But if you are using a 64 Bit Version of 7 you need the 64 Bit 7 Driver as the 64 Bit Vista Driver doesn't work in my experience.

As for scrapping the scanner I have had instances where Network Printers didn't have Vista Drivers and these things are in the 50K + Range and the companies continue to use XP as their OS's of Choice as the computers are way cheaper to replace than the Network Printer/Photocopier.

If Canon do not provide a Driver for your needs then you can change the software to something like VueScan

http://www.hamrick.com/

Which supports the FB630U amenest others or pay a programmer to write new Drivers for your Canon Scanner or just replace the scanner with a new unit that has drivers for 7.

Currently there are no drivers for this unit to work with the existing Canon Software on Windows 7 in either version.

Of course you could always depending on the version of 7 that you have use XP Mode or just blow away the 7 Install and use XP.

Or if you feel so strongly about scrapping working hardware stop using any form of Windows and go to an OS that provides better Backward Compatibility.

Sorry but they are your only options. ;)

Col

by harleyhead44

Thanks for your info into this small dilemma.
I have somehow managed to get the scanner up and running and without any problems!

I think I used the Windows XP drivers and the ScanGear Toolbox 2.2 but I'm not entirely certain because I tried so many different downloads that it got confusing.

Anyway, I used the old drivers on Windows7 (I have the 32 bit Windows) and it works.

Thanks again,
Darry

This discussion is closed to new replies.