Discussion Locked

Can't connect to internet or lan. XP Home

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
OK, here goes. I have a client's computer. After 14 trojans were removed, the internet connection failed. O/S was reinstalled. Upgraded to SP2. Firewall disconnected. Tried a new NIC. Configured w/static IP. Upgraded router firmware. Changed workgroup name. Tested cable. Rescanned for viruses and spyware. Changed dns - you get the idea. No connection to the internet. Cannot ping. IP stack appears OK. Any help appreciated.

4 replies

by rcom

You may have done/said some of this but sometimes its best to go back through t-shooting. Here's a few questions to ask yourself.

Start by checking the connections. Reseat cables or try new ones. Was this PC ever able to connect from your location? Can other PCs connect.

Remove extra gear from the chain. If this is a connection that has another unit like a cable modem connect directly to that device only. Once connectivity is restored put the router back in place.

Ping 127.0.0.1 which loops the nic. If this fails then something is wrong with the card. May not be bad but could have a conflict or something.

Did you reinstall over the exsisting OS or format and start from scratch? If you just reinstalled without formatting the drive, there may be problems still on the system that's reinfecting or causing this.

Make sure the correct nic drivers are installed.

I assume for static you mean you specified an IP address in TCP/IP properties.

Have you tried with TCP/IP and DNS set to automatic? After that open command prompt and use ipconfig to see what address is given to the nic. If its in the range of 169.254.x.x the PC isn't getting an address from DHCP.

Are you sure the static IP, subnet and gateway are correct.

By default many routers are set to DHCP and only allow addresses with the last octet above 100.

by dksells

Thank you for responding to my question. Actually the nic works on 10 mbps full duplex also. This computer is connected to a 10 mbps hub and the original nic setting was "auto", so apparently for some reason it wasn't reading the correct speed. Another card I tried also didn't work. Bug in the O/S?

Oh well, it works. I'm happy for now.

Thanks again.

by dksells

Thank you for your response. I did finally get it going. Here's the solution.

I changed the duplex setting on the NIC. It's a 100 mbps card. I had to set it to 10 mbps half duplex to get it to work. The settings are located under network connections/local area connections/properties/configure/advanced. Highlight link speed and duplex and change the value.

I hope this helps anyone else who has this problem. It was a real Headache. Thanks again.

This discussion is closed to new replies.