Discussion Locked

can't get to bios setup; boot problems

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've got a used P-133 with aGCT-8STB mainboard, 16 Mb ram and AMIBIOS. When I turn it on I get video, it shows a 133 Pentium and counts 16 Mb ram, then says wait - no beeps and hangs there. I hear the Hdd spin but have no FDD lights. Any ideas?

8 replies

by calves

Take the battery out of the mainboard and let it sit for 30 secs. replace the battery and turn it on. You should then be able to press delete, esc, whichever button to get into the bios.

Good Luck!

by bwaggoner

If pulling out the battery does not work, then hold down a key on the keyboard during bootup. It should come up with a keyboard error and tell you to press the proper key stroke to go into the bios.

by rbgnr111

try checking your hard drive jumper settings, and possibly disconnect any connections to the hard drive then reboot and hit the proper key to enter bios setup.
also sometimes if you remove one sim the computer will prompt you that the memory has changed and give you the option to go into bios settings

by finbro

Thanks I tried everything suggested but can't get a beep or error message

by r_poblete

First check your HDD jumper settings, then the HDD cable if properly connected to your hard disk to your IDE connecter on your board. If its properly connected try to check your memory location are they located at the proper memory bank bank?then try rebooting your pc ang press del or F1 or ESC to enter your BOIS setup.

by finbro

Thanks, I tried everything suggested but can't get a beep or error message

This discussion is closed to new replies.