Discussion Locked
0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have an IBM Aptiva pentiumII 450mhz. It came with Win98, and I want Win95 on it. I wiped out 98 and when i go to install 95, i can successfully copy the files over to the hard drive, but after that when i reboot to enter setup, a message appearson a black screen saying "device i/o error, press any key to reboot" and i cant get past this screen. ive tried safe mode, command prompt only, and it always does the same thing. any help would be greatly appreciated.
4 replies
by gremlintrm
Hi,
Disable the L2 cache re-enable after.
Disable UDMA mode " " "
Disable L1 cache " " "
Basically, Slow down your PC as much as needed & check for updates/bugs at Intel & MS when you can.
The error (IMHE) occurs when the CPUor HD is to fast for the MB chipset/BIOS capabilities.
You could also try removing all relevant devices from the device manager in safe-mode, eg: HD controller, soundcard, USB etc.
CU,
Glenn
by dallashoggan
i cant even get to the device manager. it wont successfully enter setup. i dont understand the first 3 lines of your reply. the only things i have access to are the autoexec.bat and config.sys files through a boot up disk.
by carlossommer
What version of Win95? If it is the first release of Win95, make sure your HD is formatted to FAT16 not FAT32 which is probably what Win98 used. FAT32 was introduced with Win95 B.
by dallashoggan
im not sure of what version, but i can find out. should i just install win 98 instead? all i want it for is client 32 for my novell server.
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
2 helpful
25 replies
Discussion
Do you think that business directories are relevant to Local SEO And Lead Generation today
0 helpful
16 replies
0 helpful
6 replies
0 helpful
12 replies
1 helpful
9 replies