9 replies
by scott.gaudet Accepted solution
by tboucher Accepted solution
by scott.gaudet Accepted solution
by svasily1 Accepted solution
Do tracert to your IP address.
C:\Documents and Settings\serge>tracert 192.168.1.1
Tracing route to 192.168.1.1 over a maximum of 30 hops
1 1 ms 1 ms 1 ms router [10.0.0.1]
2 4 ms 3 ms 3 ms 192.168.1.1
Trace complete.
If it stops on a router, you have to check ACL.
by scott.gaudet Accepted solution
C:\Documents and Settings\scott.gaudet>tracert 9txxxxx
Tracing route to 9txxxxx.xxxgrp.com [10.1.140.21]
over a maximum of 30 hops:
1 4 ms 3 ms 4 ms 10.1.130.252
2 1 ms <1 ms 1 ms 10.1.101.41
3 * * * Request timed out.
4 * * * Request timed out.
5 * * * Request timed out.
6 * * * Request timed out.
7 * * * Request timed out.
8 * * * Request timed out.
9 * * * Request timed out.
10 * * * Request timed out.
11 * * * Request timed out.
12 * *
by rkuhn040172 Accepted solution
So what is 10.1.101.41?
Do a nslookup and see what that device is. That's where your packets stop.
by svasily1 Accepted solution
Ping can,t reach reach network.
Check 10.1.101.41, may be this host acting like router. What is netmask for 10.1.140.21 if it is your host?
by rkuhn040172 Accepted solution
Right click on My Computer, System Properties, Remote, check Allow Users to Connect Remotely to This Computer.
Then, Select Remote Users and add your user/s.
Also, make sure if the Windows Firewall is on that you don't have Don't Allow Exceptions checked. Or, same basic principle for any third party firewall.
If you go into Control Panel, Windows Firewall, Exceptions, you should see an exception for Remote Desktop and it should be checked.
by scott.gaudet Accepted solution
Rick, I did previously check all what you asked me to do. I just finished, and confirmed all the steps that you ask. By looking at my settings, It should be working.
Scott
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending