Discussion Locked

Can't Telnet to Ascend P50 Router

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am looking for a work around to a self-inflicted problem. At the request of the tech guy at the ISP I was working with I set the IP address of the Pipeline router to xxx.xxx.44.11/32. I questioned subnet mask of 255.255.255.255 but he said it would work with their setup and I believed him. I saved the setting and discovered that NT and Win9x will not accept that subnet mask. I set the PC NIC to xxx.xxx.44.10/24 to open up the entire last octet to hosts but that does not work. A ping to the router gives a time out. running arp -a after ping gives the MAC address of the router. Is there any way left to connect to the router via ethernet? Is there a way to connect via MAC address? What about using a unix version of telnet? SNMP? A note: sometime before this issue the router quit responding to serial connection using HyperTerminal.

Thanks,

Dave Davis

1 reply

by fdisk

Well working for an ISP I have seen a lot of these sorts of things. The only thing to do is call Lucent (be prepared to pay up to $200 for them to tell you which wires to short and how to take the cover off.) If any one knows how to do a recovery on the router they should get the point for this question.

This discussion is closed to new replies.