14 replies
by aaron v
OK, a couple of things:
1) Do you require all 3 of those protocols? If not, get rid of at least 1 of them. If you are in a routed environment, ditch NetBEUI and use NetBIOS over IP.
2) Disable Browse Master capabilities from all machines except your NT Servers. All Win98 and WinNT workstations should be changed from Browse Master=Auto to Disabled.
3) back to routing - are you using DHCP or are machines hard coded? Can you ping from machine to machine?
4) Is WINS running on 1 or more servers? You may want to initiate a scavange on your WINS server. Make sure all of your clients point to the correct WINS server.
Good Luck!
by pheonix11
by calves
Try this:
On all the 9X machines with file and print sharing enabled, go to properties of network neighborhood select File and print sharing, go properties, highlight Master Browser and select no.
I think that the machines that have file and printsharing enabled are participating on elections for Master Browser. What happens is that if this machine becomes master browser and its rebooted another election starts, and while all of it is going on, you'll have an incredible amount of traffic in your network and the machines will have to sit and wait for a decision before they can get the word from the BDCs on who's the Master Browser.
But, then and again, I might be wrong.
Good Luck!
by pheonix11
by gbainbridge
You didn't mention anything regarding this, but another thing you should check is that the machines are in the right workgroup. This is set in the Identification tab under network properties.
Hope this helps.
by pheonix11
by pheonix11
by alantz
When I had that same sort of problem, it
was the NIC's. Some models I could update
the drivers or add Client for MS Networks.
Others I just replaced with Intel or 3com's.
Seems if I remember correctly, it was a
kingston card that was my problem.
by pheonix11
by dvn
by pheonix11
by jun1cez1
To Phoenix11,
If some of the machines cannot see anyone but can be seen by others,then i suggest that you re-check all of these specially if they are a part of a segment or subnet:
a: Clint for Microsoft Networks>properties>IP addresses, subnet mask and gateway address,
b:TCP/IP>your NIC>properties>IP address and subnet mask, you may also wish to see the DNS and WINS IP address entries "if applicable",
c: In the config Tab>client for Microsoft networks>properties>see if LOGON Validation is checked and the servers name is specified.
Goodluck
Jun
by pheonix11
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending