Discussion Locked

Cat5, Cat5e What is the difference?

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi everyone,

I'm not familar with networking to a great extend, so forgive me if this is a dumb question. I just moved to a new office. This new office has CAT5 cables already wired up inside the walls. I just bought a Dlink 100 mbps hub. I also bought some new "CAT5e" cables. Everything works fine when i connect the computers to the hub with the new cat5e cables. But when i connect the computers to the wall jacks using the Cat5e cable and then connect end of the wallcable(CAT5) to the hub Iget "Network cable unplugged". Somehow CAT5 and CAT5e doesnt get along well. I know the wiring in the wall is ok, i got it checked. I even tried a crossover cable to connect to the wall jacks incase the outlets are crossed, that didnt work either. I'll try to get an external CAT5 cable and try it again. (What is the difference between CAT5 and CAT5e anyways?) In the mean time I'll appreciate any help or suggestions.
Thanks for your time.

7 replies

by mckaytech

No, it's definitely NOT a dumb question but it is a very interesting one. The difference between Cat5 and Cat5e is supposed to be only that of maximum frequency of operation so I can't explain why you have the situation you do. The pinout and the physical specs for the connectors are the same. In my network, I have a mixture of Cat5 and Cat5e and haven't seen any problems.

The only theory I could suggest is that either the wall outlet or the plug on the patch cable is just enough out of tolerance so it doesn't make good physical contact either at the NIC end or at the wall end.

When you figure it out, I would love to know what you find.

paul

by shanghai sam

Thanks a lot for your time and interest Paul. It turns out i had made a mistake from the very beginning. All the cables from the wall outlets were hanging out from one location in a corner. I thought those cables were directly connected to the outlets. (I was told there was signal on the cables). However it turns out that the actual outlets were from a funky hub hidden in the bottom. So what are all the cables hanging out from the wall with the walljack numbers on them??.. We may never know.. :)
Thanks a lot for your time and support.
Yigit.

by cavedweller

There is more than one wiring standard. Pull a couple of jacks and check the wiring yourself. If you have no other reference, look at the Black Box catalog's wiring charts and explanations. You should be using "568b".

Both cat5 and cat5e cables are compatible with 100M utp networking and each other. You must also use cat5 wall jacks, patch panels and termination techniques. Again, the BB catalog is a nice reference with some decent pictures.

by shanghai sam

Thanks for your time and support cavedweller. It turns out I was trying to connect the wrong cables. But it's good to know all the references you have mentioned.
Thanks again.

by ann777

This is a Dlink 100 MBit hub? Not 10/100? Do you have any 10 MBit cards only in your network?

If you have a 10-MBit NIC and the hub is only 100-MBit.... that may be your problem. You may need a 10/100 Mbit hub.

Sounds like you've tried everything with the cables. Are you using an uplink port? Sometimes when using an uplink port, you cannot use the port next to the uplink (they are "shared" and with some hubs, only one of them will work at a time).

One of the hubs may be defective as well. Have you tested with another spare hub?

by shanghai sam

Thanks a lot Anna. I figured the problem. But it's very good to know about the uplink port. That issue would probably be my 2nd future problem :)

Have a great day.

This discussion is closed to new replies.