Discussion Locked

CD-ROM Drive and DMA

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I noticed in device manager under cd-rom drive that I have a box for DMA and I would like to know if enabling DMA will be beneficial for my system? I have 98SE 366MHz with 64MB of Ram. I have DMA enabled for other areas right now.

8 replies

by sdombro

It is going to speed up your system. The CD-ROM will use the motherboard ressources instead of using the CPU. I recommend you enable it.

by avachon

Hi, to add to respondent #1:
DMA refers to direct memory access (also referred to as bus mastering). It allows some components and devices to transfer data directly to and from memory without passing through the CPU. To find more extensive information about DMA, take a look at the article Q258757 in the microsoft knowledge base (www.microsoft.com) I hope this helps.

by puya

Enabling DMA access is always good because the data from the CD(in your case) will be taken directly in the memory by your motherboard chipset whitout stressing the CPU. Windows may give you a warning message saying that this could conflict...blah,blah,blah, but you can safely ignore this if you got a newer CD-ROM. If your computer freezes the next time you boot (very unlikely) you will need too boot in safe mode (keep Ctrl pressed when "starting windows 98" is displayed and select Safe mode) and uncheck the "enable DMA" box.
Hope it helps!

by saihib

Do your homework first and check with the CD Drive manufacturer to make sure that your particular unit supports DMA data transfers. If not, checking the box will be a waste of time and might make your machine run erratically.

This discussion is closed to new replies.