Discussion Locked

CDROM and CD Burner Drives gone!

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running Windows ME.

For some reason, my CD ROM and CD Burner drives are no longer recognized by windows when I reboot.

The CD ROM drive door will not open when I press the button. I don't think it is a power problem because the light usually comes on for a while during boot up.

As for the burner, the drive does not appear after boot up. But if I put a blank CD in and the ADAPTEC software prompts me how I want the CD formatted. After that, the Drive seems to be known to windows until I reboot.

9 replies

by true_texan

Sounds to me like you have a problem with your CD ROM. The button on the CD ROM should open drive whether or not it's connected to a computer system (as long as it has power of course).

Look at your CMOS setup to make sure that your system is still seeing both drives. Check to see which controllers the drives are on.

My guess is that something happened to your CD ROM. If they are both on the same IDE controller, the CD ROM may be causing a problem with ME seeing both the ROM and burner.

You also might check for a virus and check to see that you haven't recently removed anything in the MSCONFIG startup that the drives are needing.

Also check to make sure that anything you have installed recently isn't causing a conflict. Youcan easily do this by looking at the Device tab in your Control Panel > System.

Hope this helps.

by geek2d

The part about the drives being gone for no explainable reason I have experianced. Now this may not be the problem but on my 2000 pc if i boot it up and leave a music cd that I burned in the drawer then it will magicly dissapear. I take the cd out and reboot and it is back and will play the cd as soon as i put it back, it doesn't do it with manufactured music cds... go figure. Anyway I would also recomend that you look at your drives and make sure that they are not set to cable select, they should be master and slave. Then you should also be sure you have the latest BIOS, that seems to fix a lot of off the wall hardware issues.
Good luck

by @lberto

I agree with the answer #1, but I think that you have 2 different problems going on here.
Check if the BIOS detects both CDRom drives, if not, then remove your computer cover and try each CD rom at the time, remove the IDE cable from one, start your computer up to see if it detects it, if so, then the next one. If it doesn't detect one of them means you have a hardware problem. If the BIOS detects both then before Windows starts up try to open your CDRom, if it doesn't open your CDROM is not ok, you have to buy a new one. if it opens then lets start up Windows, go to Device Manager and see if is there any hardware conflicting or a yellow ?.
If you get any yellow ? then you've to reload the drivers of your cdrom.
Please e-mail me back ifit doesn't help, there some other things we can check ...

Good luck,

@lberto

by philthegreat

Software:
1) Re-install the CD Burner Software because it helps to recognize the CD-burner.

Hardware:
1) If you press the button; but the CD really don't respond; then it may have some hardware problem; the rubber may be loose.

This discussion is closed to new replies.