Discussion Locked

cdrom doesn't recognize disk change inXP

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a new Athlon 1.3 ghz with an epox 8kha+ mb and running windows xp home and 256 mb ddr ram. I have a new Polaroid 24X10X40 burner installed. When I boot up the machine and stick in a cdr which I know has something on it it shows up blank. Iload Nero burning rom software and say continue session and I can see the files on the cdr disk. I then go to my computer and look on drive D (the burner) and I can see the files. I then put in a different disk (which I think has been written witha burner) and it shows up blank, but I know there are files on it. I then put the first cdr disk back in and now it shows blank again too. Is it just a setting in XP or something? Thanks

5 replies

by thechas

Have you installed the XP cd burner update?

This is where you need to start.

I would also check and see if nero has any XP updates.

There have been a number of XP cd recorder problems. I would install both the cd recorder, and the softwarecompatability patches.

My drive didn't recognize CD-RW disks with data on them until I installed the updates.

by rob_jantz

Hi, I installed the latest updates for nero and it didn't help. I finally sent the computer in and they uninstalled InCd (packet writing software) and now it will recognize disk change. Thanks for your time.

by 1stladytech

What is sounds like is going on is that you are burning the disks, but not closing the sessions. These sessions will not appear in non-cdrw drives, and will only appear in cdrw drives after you reinitialize the session (continue the session) Try to burn a disk, making sure that the software closes the disk, (no further data addition possible). Then try the same routine, I think that you will be able to see the data on the cd's.
Hope this helps,

Vickie

This discussion is closed to new replies.