Discussion Locked
0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I've upgraded my mother board from an Intel D865GBF to a D915GAV. I booted from the XP Pro CD and went to the Repair prompt. Upon rebooting after the copy, the PC just continually reboots and doesn't go into the repair procedure as it normally would. The Bootable CD is XP Pro w/SP2. The hard disk is a 160MB Maxtor with approx. 50GIG in use. System has 1MG of DDR-400 ram. Big system lots of hardware, printers scanners, zip, jaz, etc... Any thoughts on what to do to get system to reinstall?
5 replies
by dmiles
There is a hardware change so XP activation may be causing the problem,the solution may be to install a fresh copy on the system
Repair option does not apply in this instance,therefore the system is rebooting becuase it has hardware change
by bob_cdr
Poster rated this answer.
by bob_cdr
This question was closed by the author
This discussion is closed to new replies.
Trending Desktop posts
Sort by Trending
Question
Floppy drive wont work on my 486
0 helpful
1 reply
Discussion
How to make light speed agent go away
0 helpful
4 replies
0 helpful
1 reply
Discussion Locked
Ryzen 7 7700
0 helpful
2 replies
Question Locked
Issue fully resetting my PC
0 helpful
4 replies