Discussion Locked

Change of DHCP servers

0 helpful
14 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We currently have DHCP service running on a Novell box. We will be moving that service onto a Windows 2000 server. Can we just shut down the Novell DHCP server and boot up our W2K DHCP server, or is there something else we need to do? I'm sure others have gone through this already.

14 replies

by hstahl

I don't know much about Novell, so I'm going to base this answer on Novell having similar functions to NT. Here's what I would do:

Don't shut down your old DHCP server right away. Instead, disable its range so that it will issue NACKS to clients. At the same time bring up the 2000 DHCP server w/ the same scope (or different if you're switching IP schemes). So when the client gets a NACK from the Novell it will send out another request and get an IP from 2000. Once all your clients have received IP's from 2000 shut down the DHCP on Novell for good.

-Heath

by hstahl

FYI: the reason I said to leave the old one running giving out NACKS instead of shutting down as suggested is that if your network/users are like mine you can't insure they will all shut their computers off at night. I'm trying to save you all the help desk calls you'll have the next day about network access.

by walterzalewski

Wait until the end of day (or slowest part of the day if 24 hours operations) and replace the server. Also make sure all of the workstations are shutdown the night before. You shouldn't have any problems. The workstations will check with the DHCP server when they start up and will be reassigned a new ip address. I have a guest side and admin side network, both completely separate, logically and physically, with machines that are used alternately between them without any problems. Hope that helps,good luck.

by Former member

Shut down all workstations. Shut down Novell. Start up W2K. Startup workstations. This will avoid duplicate addressing from old to new.

by maz1980

You don't need to shutdown your workstation. Just stop DHCP service on Netware as the W2K ready to become DHCP server( make sure the configuration is correct) then boot up the W2K DHCP server. The new W2K DHCP server will recognize which IP that have been used.

by maz1980

You don't need to shutdown your workstation. Just stop DHCP service on Netware as the W2K ready to become DHCP server( make sure the configuration is correct) then boot up the W2K DHCP server. The new W2K DHCP server will recognize which IP that have been used.

by maz1980

You don't need to shutdown your workstation. Just stop DHCP service on Netware as the W2K ready to become DHCP server( make sure the configuration is correct) then boot up the W2K DHCP server. The new W2K DHCP server will recognize which IPs that have been used.

This discussion is closed to new replies.