Discussion Locked

Changing IRQ of NIC adapter

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Is there an alternate method of changing the NIC adapter on an NT workstation? I have an Adaptec 1510 SCSI that MUST use IRQ 11 and an IBM Netfinity NIC that also uses 11. The dialog box for the Network adapter properties has been changed with the installation of the NIC and the "change" button has been removed.

5 replies

by ulairi

If you cannot do this with the driver, you can do it with the BIOS. Different BIOS makers use different terminology AMI ones in the SuperMicro motherboards, for example, use "PCI Slot Priority" when they REALLY should say "PCI Slot IRQ Assignement".

by mike

Check the adapter to see if there are any hard jumpers, I think that the 1500 series has a set of hard wire jumpers that you can strap to configure it.
Mike

This discussion is closed to new replies.