Discussion Locked

Changing MAC Address on Nic card

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I want to change the MAC address on a NIC card to show a set number(due to the software i need to run is only licenced to that number, and for potential backup if the existing NIC card malfunctions)
is this hardware based or software?
thanks

5 replies

by ratherbfishing

The MAC address is hardware based, and you cannot change it. I have also run into this problem with software licensed to a NIC card. You have to contact the Software vendor and tell them you are changing NIC cards, and they should reissue the license for the new card.

by sfo farmer

Answer #1 is right on target- There is no way on a standard NIC to change the MAC. I've run into the same situation also with Computer Assoc. products- they will relicense you. You may want to ask the software publisher what to do if you have two NIC or a dual port/fault tolerant NIC setup.
By the way- the only time I have been able to change a MAC is on test equipment like a Fluke LANMeter.

SFO

This discussion is closed to new replies.