Networks
1- I have 50 telephone line with 500 dial up users,
How much bandwidth do I need ?
2- I want to connect two WAN to each other by a 1Mbps Leased Line .
I have two 3640 Cisco Router at each end point .
How can i do this ?
by mckaytech
1. The total number of users doesn't really matter since only 50 can connect at a time. With something like a Cisco AS5300 Access Server, you can probably figure on needing two T-1 (1.544mbps) lines to handle the traffic for 50 users. This is wellwithin the capability of a standard Ethernet interface between the communication server and the network.
2. Install a Wan Interface module (WIC) in each 3640 and connect that to the leased line. Once the line is up, you just need to tell each router how to find the other network (whether by a routing protocol or, more likely, by a few static routes). You'll probably have to tweak the configuration a little and may want to add access lists to control the type of traffic that goes over the WAN, but the basic setup is pretty simple.
paul
by pardarling
thanX sir :)
but T1(and E1) lines are very expensive here,
they want 16250$ for deposite,
and more than 7000$ monthly charge :(
Could you tell me a better solution ?
best wishes
by pardarling
This discussion is closed to new replies.
Sort by Trending