Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I can not talk to this Cisco 1700 router, I have no documentaion and the cisco website says "just connect blue wire to terminal emulation software and back of router" How can I connect to this router. Any help is appreciated
6 replies
by keithnva
Point value changed by question poster.
by ikrick
The Blue wire they refer to is a cisco console port cable. It has an rj45 on one end, and you will need a 9 pin adapter for the other end. thew 9 pin adapter attaches to a serial port, and then you wil use hyperterminal to access the router
by keithnva
My mistake at leaving a vague question-- I knew how to connect the serial cable to the router, turns out the IOS had been wiped -- so no connection was available till I tftped the router
by alpha-male
This "wire" is a rollover cable an will allow you to interface with the router. You should be able to get one from Cisco, on Ebay or from many computer stores if they have a decent cabling selection. You'll connect the cable to the console port mostlikely called console or Con 0 etc.
Good luck, hope this helps.
by keithnva
Poster rated this answer
by keithnva
This question was closed by the author
This discussion is closed to new replies.
Trending Networks posts
Sort by Trending
Question Locked
Internet connection perfect on PC, not connecting anywhere else
0 helpful
4 replies
Question Locked
Using multi-NIC setup for NAS + router — better than VLAN?
0 helpful
4 replies
0 helpful
5 replies
Question Locked
Unknown device connected to my network
0 helpful
2 replies
Question Locked
How to change public IP without ISP?
0 helpful
2 replies