Question Locked

Cisco 2600 Router Config Problem

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

While attempting to update the IOS on my Cisco 2600, I came across a large problem. I cannot access the priv exec mode, and it goes something like this:

Router>en
%no password set
Router>

Has anyone ever seen this before? This router is hardly ever used, so I'm not sure what happened the last time it was touched. It does not prompt me for a password, and I've attempted to break into it with no results.

I'm hoping I don't have to reload the router, but I have come across nothing.

Help! :)

4 replies

by romanetebar

I would greatly appreciate if someone could assist me with the following problem:

It seems like my home router configuration is stuck in a routing loop or something

Here is my configuration

FIOS Router is connected to ISP
192.168.1.1
Default Gateway for all hosts on the 192.168.1.x subnet

There is a static route on the FIOS Router to send all traffic to 10.20.20.x via 192.168.1.254

Cisco 2600
Fastethernet 0/0 : 192.168.1.254 directly connected on the same switch as FIOS Router 192.168.1.1 ( dumb switch)

Fastethernet 0/1 : 10.20.20.1 directly connected to an 8 port (dumb switch) with a single host on the same switch (10.20.20.2)

Gateway of Last Resort : 192.168.1.1

Here is my dilemma:

Hosts on 192.168.1.x can traceroute to hosts on 10.20.20.x subnet and the packet get there in 2 hops from 192.168.1.1 to 192.168.1.254 to the destination, no problem

Hosts on 10.20.20.x unable to get out to the Internet or ping 192.168.1.x hosts; however, a host on 10.20.20.x can successfully ping the FIOS router 192.168.1.1

Have I created a routing loop inside the Cisco 2600 ?

This discussion is closed to new replies.