Discussion Locked

Cisco 2611 NAT DHCP question

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi all

I got a Cisco 2611 router and I am trying to set up a basic home network configuration. I set up interface e0/0 which connects to the cable modem to "ip addr dhcp" and e0/1 as DHCP server 192.168.1.0 All this is working fine now.

Now I understand that I also need to setup NAT to be able to access the Internet from inside the home network. I saw some commands for NAT but I noticed that you have to specify the global IP address there. What if I get my IP by DHCP from the ISP? How can I specify that for NAT?

I guess I also need to set up some access lists to protect my network.

Any help is greatly appreciated.

Thanks.

3 replies

by akshaydere

Hi,
how many systems do you have configured in your home network?
It is not mandatory to configure NAT just to access internet.
Once you are connected to the ISP using your cable modem, simply use the " ipconfig /renew " command from Command and it will automatically assign the IP addresses from the DHCP pool.

Or if you can get the pool of the IP addresses from your ISP which are configured for DHCP, you can configure it on your router itself....

by evilbob

You can also apply NAT to an interface rather than ip address. ip nat inside source list interface overload. Can you send a copy of your configuration to evilfux0r@gmail.com, minus your passwords and internal IP's of course. :)

This discussion is closed to new replies.