Discussion Locked

Cisco 2621 Routers and IP Helper-Address

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hello,

Currently I am trying to resolve an issue on our routers. We just switched from one DHCP server to another on all subnets (Windows NT 4.0 to 2000). I have setup on each router a new ip helper-address to reflect the new Windows 2000 DHCP server. I have correctly configured this but would like to write it permanently to the router configuration. What is the best command(s) to research regarding...I have seen commands such as

write running-config startup-config

but that doesn't appear to set it permanently

Thanks,

Chris Arsenault
Network Administrator
Houston, TX
chrisamcp@hotmail.com

5 replies

by chrisamcp

Thanks for the help! I was a bit concerned only about power loss!!! Obviously if the running config disappeared...so did everyones route to the DHCP SERVER!! Worked great :)

Chris A

by wlbowers

This is taken right off a telnet session on our 2621. It shows the command and the response you will get.

User Access Verification

Password:
SS_MEM_2600>en
Password:
SS_MEM_2600#write mem
Building configuration...
[OK]
SS_MEM_2600#

Good Luck Lee

by chrisamcp

What would this be in comparison to

copy run start

:)

Thanks for the help

Chris A
chrisamcp@hotmail.com

This discussion is closed to new replies.