If I understand your question correctly you need three different departments with different IP schemes on the same router.
In order to do this your going to have create sub-interfaces on your router. Each sub-interface will correspond to your department/ip scheme. See below
interface FastEthernet0/0
no ip address (no ip address on main int)
ip helper-address (dns address if needed)
duplex auto
speed auto
!
interface FastEthernet0/0.10
description Teaching Network
encapsulation dot1Q 10
ip address 10.x.x.x 255.255.255.0
!
interface FastEthernet0/0.172
description Non-Teaching
encapsulation dot1Q 172
ip address 172.x.x.x 255.255.255.0
!
interface FastEthernet0/0.192
description Students Network
encapsulation dot1Q 1 native (This is my native network)
ip address 192.x.x.x 255.255.0.0
Additional note: You only need one of the NICs to do this. The switch port that the router plugs into also has to be configured as a trunk port tp be able to pass multiple vlans across the uplink. You will also have to add each port to the appropriate vlan. For example, "switchport access vlan 192" will need to run on each port that is part of the student network. The gateway of each one of your student PCs will be the 192 address of the sub-interface.
Hope this helps.
Mark Combs